- Machining center
- Z-axis acceleration 0.75G minimizes tool changeover time.
- Rapid feed 42/42/42 m/min minimizes non-cutting time.
- Directly-coupled 12000rpm spindle assures part surface finish.
- Supreme rigid column increases milling & tapping efficiency.
- Easy access to working area and perfect swarf and coolant disposal.
- High rigidity dynamic structure
- Heavy-duty MeehaniteR castings from Victor’s licensed foundry are used in the bed and column for maximum damping and strength.
- Supreme rigid and tough column with a heavily ribbed design enables the high Z-axis acceleration for high speed movement.
- AE (computer aided engineering) design with span 800 mm in Y-axis results in a maximum stiffness to ensure the minimum overhang distortion for whole X-axis traveling range 850 mm (for VcenterII-550) or 1100 mm (for VcenterII-550L).
- Arm type ATC
- Twin arm type ATC with bi-directional random selection for 24 tool magazine offers quick tool change and optimal reliability. This tool capacity can be optional increased to 30 tools for more complicated applications.
- Chip-to-chip tool changeover time is just 4.3 seconds.
- Upgraded SK-40/BT-40 tooling system linked with the stronger tool pull stud (O14 mm) enhances the heavy cutting capability and outputs more CTS coolants than conventional BT-40 tooling with O10 mm pull studs.
- Directly-coupled Spindle (DCS) with high torque spindle motor
- Spindle motor is directly coupled to the spindle to avoid the vibration resulted from belts and enhance surface finish on components.
- 12000 rpm spindle speed with high torque output accommodates both heavy cutting at low rpm and high speed machining.
- Two types of spindle motors meet the power requirement for milling steel and speed requirement for milling Aluminum.
- Oil-air lubrication with filtration system is used for spindle bearing and air dryer has been included as standard to further assure air quality for ultimate service life for the spindle bearings.
- Air curtain has been added to constantly give the spindle an extra coat of protection.
- Spindle oil cooler is included as standard to remove the heat around the spindle cartridge for maintaining the low temperature during the spindle rotation to ensure the long service life on the spindle bearings.
- High damping guide ways with high stiffness
- Ballscrew holders are directly cast into the machine for even higher rigidity and strength. This ensures a constant support for the ballscrews over the entire machine life.
- Large diameter 45 mm ball screws and big size linear guides (width 45 mm) ensure the high structure stiffness during machining.
- Direct coupled servo motors eliminate motor backlash and noise caused by misalignment.
Machine Layout and Specification(Metric) Machine Layout and Specification(Imperial)
THE VICTOR-TAICHUNG COMPANIES
was marked under the brandnames 
(outside North America) and 